E-Revo Two-Speed Instructions

Part of content:

E-Revo Two-Speed Instructions










E-Revo Two-Speed Instructions
www.TRAXXAS.com
Traxxas, 1100 Klein Road, Plano, TX 75074, Phone: 972-265-8000, Fax: 972-265-8011, e-mail: support@Traxxas.com
KC1145 Rev 080702
Covers Part #5692
Note: This kit requires a 3-channel transmitter, not included (TQ-3 3-channel transmitter available separately as Traxxas part #2225).
Remove Transmission From Vehicle:1. Remove the upper gear cover from the transmission by removing
the 3x8mm button head screw with a 2mm hex wrench.
2. Remove the motors from the transmission. Using a 3mm hex wrench,
remove the rear motor and finned mount assembly as a unit, and remove the front motor by removing the two 3x6mm cap screws with a 2.5mm hex wrench.
3. Using a 2mm hex wrench,
unscrew the M4x15 screw pins from the output yokes (A), and remove the drive shafts from the transmission. Gain access to the rear driveshaft by using a 2mm hex wrench to remove the rear driveshaft access cover.
4. Using a 2.5mm hex wrench,
unscrew the four 4x12mm button-head screws securing the transmission and remove the transmission from the chassis (B).
Install 2 Speed Kit Into Transmission:1. Using a 2mm hex wrench, separate the
transmission case halves by removing the six 3x12 countersunk screws (C).
2. Remove the main output shaft (D1) and remove
its stock gear (D2).
3. Install the selector disc, then, sandwich the two
included drive gears on either side (E), noting orientation of each gear as shown. Slide the supplied white nylon spacer onto one end of the shaft, and the grey Teflon washer on the other. Note: Each output gear features a shallow side and a deep side. The deep side of each output gear faces the selector disc (F).
4. Insert the selector fork into the selector disc
and reinstall the completed assembly into the transmission in the orientation shown (F). Note: It is imperative that the end of the assembly with the white spacer be inserted into the front half (spur gear s