TC-38 Transfer Case Service and Parts Manual
Filesize: 646486 Byte
ShareBy: Jenny
There are 401 vistors like this document,if you also like,dig it!
Click Here To Download...
Part of content:
TC-38 Transfer Case Service and Parts Manual
151 LAWRENCE DRIVE LIVERMORE, CALIFORNIA 94551
TELEPHONE (925) 454-9500
FAX (925) 454-9501
Part numbers contained in this manual were in effect at the time the manual was approved for printing and are
subject to change without notice or liability, Fabco Automotive Corporation reserves the right to change parts at
any time.
AUTOMOTIVE CORPORATION
TC-38
Transfer Case
SERVICE MANUAL
Before ordering parts for a Fabco transfer case, please refer to the Fabco nameplate located on the
transfer case housing. Specify model number, serial number, part number, or other information that is
on the nameplate when ordering parts.
I. LUBRICATION
A. Initial oil change should be made after no more
than 5,000 miles have been driven.
B. Regular oil changes should be made at an interval
selected by the user. An interval between every
10,000 to 15,000 miles should be satisfactory
unless operating conditions indicate a lesser inter-
val is necessary.
C. The location of the drain, fill and level plugs is
indicated on the next page.
D. Proper lubricant level is to the bottom of the oil
level hole.
E. Check lubricant level at regular intervals; watch
for indications of possible oil loss.
F.
Approximate oil capacity is 7 quarts.
625 417
Copyright © 1988 by FABCO AUTOMOTIVE CORPORATION
LIVERMORE, CA 94662
1
1
On Highway Vehicles
Type
MIL-L-2104B
Heavy-Duty Engine Oil
Mineral
Gear Oil
MIL-L-2105B E.P.
Oil, except sulfur-chlorine-lead type.
Grade
SAE 50
SAE 30
SAE 90
SAE 80
SAE 90
SAE 80
Temperature
Above + 10°F.
Below + 10°F.
Above + 10°F.
Below + 10°F.
Above + 10
o
F.
Below + 10°F.
Heavy-duty engine oil. Make sure to specify heavy-duty type meeting MIL-L-2104B specifications.
Mineral gear oil inhibited against corrosion, oxidation and foam.
Extreme pressure oils under some conditions might form carbon deposits on gears, shafts and bearings which
will result in transfer case malfunctions and premature failure. It is su
Download TC-38-Transfer-Case-Service-and-Parts-Manual.pdf
- YUKON Inst manual(final)
- SCT Rabbit - Supplimentary Operator's Manual
- Download Gear Failsafe instruction manual
- Software User's Manual
- Sturmey Archer manual
- Owner's Manual Owner's Manual Owner's Manual Owner's Manual Owner's Manual
- REDCAT 110 (KMX-110) Quad Manual
- ELECTRIC TOOL PARTS LIST
- AERO GEAR, INC. SUPPLIER QUALITY MANUAL
- Rekluse ProStart Clutch Owner's Manual
- Six-Speed Manual Tremec T56 (MM6/M12) Car Transmission
- OWNER'S MANUAL 2006
- 1997-2004 C5 Corvette w/ 6-Speed Manual Transmission including Z06
- Educational programs of the Texas Agricultural Extension Service are ...
- Pirelli / Moose Racing / Parts Unlimited / Maxxis
- Saturn Outlook
- KNIGHT PROWLER BELT DRIVE® INSTALLATION INSTRUCTIONS
- www.bmwmoa.org/ownersnews/advertisers.txt
- Motorcycle Items For Sale. Contact Shane Patishnock, 410-939-4780 for ...
- Evolva 2005 Notes
- Software User's Manual
- Junior Solar Sprint - An Introduction to Building a Model Solar Car
- www.et.byu.edu/~ered/ME437/PowerPt/14_Gears.ppt
- US-LT41P SERIES SCREWDRIVERS
- 1. Digital Gear Indicator (DiGI) - Installation Instructions