Microsoft Word - Document1

Part of content:

Microsoft Word - Document1











SECTION - 5
LATE MODEL DIVISION - 2008
Open to two-wheel drive American automobiles provided they comply with, and adhere to, specifications as outlined for this division.
NOTICE
ALL EQUIPMENT IS SUBJECT TO THE APPROVAL OF FRRC OFFICIALS. NO EQUIPMENT WILL BE CONSIDERED AS HAVING BEEN APPROVED BY REASON OF HAVING PASSED THRU INSPECTION UNNOTICED. EFFORTS TO TAKE ADVANTAGE OF LOOP HOLES IN THESE RULES WILL NOT BE TOLERATED. ALL RACE CARS ARE SUBJECT TO INSPECTION BY TRACK OFFICIALS AT ANY TIME.
5.1 COMPETING MODELS AS APPROVED BY FRRC
FRRC Late Model races are open to approved 1996 to 2008 models of American made passenger cars.
5.1.1 Approved Competition Models
The following are approved competition models:
CHEVROLET
1996-2008Monte Carlo
DODGE
1996-1998 Avenger 2001-2008 Intrepid 2005-2008 Charger
FORD
1999-2008 Taurus
PONTIAC
1996-2008 Grand Prix
All cars must maintain a wheelbase of 104.0 to 108.0 inches at all times. The maximum overall width of all cars, as measured from the outside of the right body or tires to the outside left body or tires, is 82 inches. The maximum tread width for these cars is 65.0 inches, measured at spindle height.
5.1.2 Other Approved Models
Other models may be approved, provided they are of the same body configuration and meet the spirit and intent of competitive racing. ASA Late Model Series cars may compete in the Late Model Division as long as the car is in compliance with all ASA Late Model Series rules. ASA Limited Late Model Series cars must comply with Section 5.7.3.3 Tires. FRRC reserves the right to exchange any carburetor, on any ASA Late Model Series engine, at any time.
5.1.3 Identification and Marking
FRRC reserves the right to assign car numbers, and to assign or restrict the display of graphics and advertising on race cars. Offensive graphics or slogans are not permitted. All Competitors agree to accept FRRCs decision in this matter. Officially issued numbers must be at least 16 inches high by 3 inches wide and neatly applied (paint or decals) to both doors. Numbers, as large as possible and in contrasting colors to the body, must be applied to the right front corner of the roof, front headlight cover, and rear taillight cover. Where requested, participating sponsors emblems, or decals will be placed in the position designated by FRRC Officials. Failure to place participating sponsors emblems on a race car may result in ineligibility for contingency prizes.
5.2 GENERAL CAR WEIGHT REQUIREMENTS
5.2.1 Overall Car Weight
The specific minimum weights for all cars are listed below. No fuel burnoff allowance for qualifying. All weights are with the driver. All cars must maintain the minimum right side percentage of the total car weight, at all times.








Minimum

Minimum
Right Side


Car